ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
![]() | 1 | initial version |
To debugs this you're going to need to disassemble your TurtleBot. You'll need a DMM as well.
Remove the platters from your TurtleBot so that you can get at the TurtleBot power board. Put your DMM in DC voltage mode and touch pins 8 and 14 with the DMM probes and to read the voltage. The voltage should be 5V. If the voltage is not 5V this is most likely a problem with your irobot create base, if it is 5V this is most likely a problem with your power board.
![]() | 2 | No.2 Revision |
To debugs debug this you're going to need to disassemble your TurtleBot. You'll need a DMM as well.
Remove the platters from your TurtleBot so that you can get at the TurtleBot power board. Put your DMM in DC voltage mode and touch pins 8 and 14 with the DMM probes and to read the voltage. The voltage should be 5V. If the voltage is not 5V this is most likely a problem with your irobot create base, if it is 5V this is most likely a problem with your power board.
![]() | 3 | No.3 Revision |
To debug this you're going to need to disassemble your TurtleBot. You'll need a DMM as well.
Remove the platters from your TurtleBot so that you can get at the TurtleBot power board. Put your DMM in DC voltage mode and touch pins 8 and 14 with the DMM probes and to read the voltage. The voltage should be 5V. If the voltage is not 5V this is most likely a problem with your irobot create base, if it is 5V this is most likely a problem with your power board.
Top down view of the power board header pins:
![]() | 4 | No.4 Revision |
To debug this you're going to need to disassemble your TurtleBot. You'll need a DMM as well.
Remove the platters from your TurtleBot so that you can get at the TurtleBot power board. Put your DMM in DC voltage mode and touch pins 8 and 14 with the DMM probes and to read the voltage. The voltage should be 5V. If the voltage is not 5V this is most likely a problem with your irobot create base, if it is 5V this is most likely a problem with your power board.
Top down view of the power board header pins:
pins:
![]() | 5 | No.5 Revision |
To debug this you're going to need to disassemble your TurtleBot. You'll need a DMM as well.
Remove the platters from your TurtleBot so that you can get at the TurtleBot power board. Put your DMM in DC voltage mode and touch pins 8 and 14 with the DMM probes and to read the voltage. The voltage should be 5V.
Top down view of the power board header pins: