ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
![]() | 1 | initial version |
I had the same problem; no laser data is shown in rviz unless the laser's frame is set as the fixed frame.
I found a thread on the ros-users list that suggested it had to do with the time_increment field being too large. I noticed there is an error in the LMS1xx package I'm using as a driver for the laser. The fields time_increment and scan_time are ten times as high as they are supposed to be.
I think this was the cause of the error message. What's annoying is that it took 20-30 minutes after I fixed this for it to actually start working. I don't know why it didn't start working immediately. It's possible I restarted rviz at that stage, or managed to reset its laser module. I sure didn't change anything else, at least.
Here's the list thread I mentioned: http://comments.gmane.org/gmane.science.robotics.ros.user/5192