Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

The joints would be modeled as revolute in URDF, just like any other joint. For pneumatic/hydraulic actuators, I believe you'd be dealing with an EffortInterface for your actuator (http://wiki.ros.org/ros_control#Hardware_Interfaces), with the appropriate limits (http://wiki.ros.org/ros_control#Joint_Limits).

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.