ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Thank you for your help. I am not too keen compiling from all the sources since there may be problems with dependencies But the RPi 3 has - as you know an ARM processor - so I am beginning to think that perhaps doing a compile job may well be the best way.
May need help - a lot of help perhaps.

Probably the best solution would be a different main board that can run a pre-compiled package.

.Any suggestions there?

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2