ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

After JayNewman's comment I tried sending the entire trajectory to the Arduino so that I could store it and then execute it once I received it all. Even though the communication between the two processors (Arduino side and Linux side, both on the board - using Bridge) is quite slow, the trajectory eventually makes it to the Arduino side which then executes the trajectory smoothly.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2