ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

i had the same problem and i solved it. So why the exporter just stopped ? this is because the exporter can not create for example the axis of a revolute joint when you leave the option "automatically generate". In my case, i had defined fully 3 mates for the realated object, so the exporter could not find the degree of freedom to assume that the part can revolve( be free) around an axis. Hope this helps

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2