ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Hi All,

I believe there is a bug in Nuttx Menuconfig.

When I set micro-Ros to Serial Transport,

Application Configuration > micro-ROS > Transport > Serial Transport

Serial port to use -> /dev/ttyS1 (I believe this is an issue for embedded system.)

/dev/ttyS1 is only for host computer and it is not for embedded system board.

Please advise me how I can set a correct settings for Serial port to use in Nuttx menuconfig.

Thanks.

Regards, Thiha Kyaw

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2