The site is read-only. Please transition to use Robotics Stack Exchange
| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
 | 1 | initial version |
I can confirm that I've successfully sent data from a windows computer to Linux using fuerte. I followed the instructions for setting up the SDK on Windows 7 and then built a ROS node using Visual Studio. I was able to send both data and video to a Linux computer over the network (with roscore running on the Linux box). Other than changing ROS_MASTER_URI, the only other thing I can remember that I did was to add entries to the hosts file on both the Windows and Linux computer (to make sure each computer had the correct IP address of the other).
| | 2 | No.2 Revision |
I can confirm that I've successfully sent data from a windows computer to Linux using fuerte. I followed the instructions for setting up the SDK on Windows 7 and then built a ROS node using Visual Studio. I was able to send both data and video to a Linux computer over the network (with roscore running on the Linux box). Other than changing ROS_MASTER_URI, the only other thing I can remember that I did was to add entries to the hosts file on both the Windows and Linux computer computers (to make sure each computer had the correct IP address of the other).
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
