ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Well, I think I might have found the root of most of my problems. I was getting the most spinning when I set the xy_goal_tolerance to 0.05 or less. But I just realized that my blank map only had a resolution of 0.05. When I set the map resolution to 0.01, I was able to get good behavior without all the spinning. So perhaps in the end that's all it was...

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2