ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange

Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

I tried overwriting the existing files (in /opt/ros/groovy/lib) with a fresh compile/install of opencv. It doesn't crash but it doesn't show the gui either. Oddly enough, the same behavior happens on a 64bit Ubuntu 12.10 installation.

My fix has been to install the fuerte version (sudo apt-get install ros-fuerte-image-pipeline) and run the fuerte version of the calibration. It works fine on Ubuntu 12.04 32bit.

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.

Powered by Askbot version 0.10.2