Attention: Answers.ros.org is deprecated as of August the 11th, 2023. Please visit robotics.stackexchange.com to ask a new question. This site will remain online in read-only mode during the transition and into the foreseeable future. Selected questions and answers have been migrated, and redirects have been put in place to direct users to the corresponding questions on Robotics Stack Exchange. Additional details are available here.

Revision history [back]

Is it possible that you run a .cpp file from the "laser_scan_assembler" ? I think you start the same node again, which ends in an shutdown because you have the same name twice. If you wanna run it both together then change the name in the .launch file, e.g to "laser_scan_assembler_1"

ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.