| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
During the homing (or reset) if one of the motors touches an obstacle it stops. I wish also during the phase of achievement target position in case of contact with any object the motor concerned to stop. How can I do? Can I modify the topics?
If for example the finger is supposed to reach 400mA but is stuck and only manages to get up to 200mA the threshold will not be reached. In such cases the reset timeout should abort the timeout after the amount of seconds specified. However the timeout is only active once there is no measurable difference in current.
In case the current changes a little bit but does not reach the threshold it will be in an infinite loop. In this (rare) case stop the driver execution, maybe restart the hardware, and set a lower reset current factor.
I want that the motor stops if it touches an object, during the contact the motor reach a current limit (isn't it?) but the motors don't seem to stop. Why?
Hey Alba,
maybe you confuse the two operation modes?
Reset/Homing:
During homing, the fingers will stop when they hit a hard stop. This is the desired behaviour as the fingers try to find the maximum movement range. If you block them during this movement they will not be referenced properly
Normal movement:
During normal operation the controllers will try to reach the target position you have given them. Refer to this answer.
Best Regards Georg
Asked: 2015-04-30 09:55:20 -0600
Seen: 835 times
Last updated: Jun 06 '15
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
what do you really want? the motors seem to stop when they reach a current-limit or a reset_timeout, so if through your "phase of achievement target position" it will stop if there is something in the way of the fingers, or?