| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
So I know you can save a map to disk once your robot has mapped an area, but when you reload it, is it likely the robot will know where it is or do you need to set its pose?
The reason I ask is, when the hector slam gets confused, the whole map goes haywire, it basically loses its rotation etc.
Now I want to be able to map an area once. Then uses it over and over again.
"is it likely the robot will know where it is or do you need to set its pose"
"It depends" is the answer in my experiance. AMCL for example can sometimes figure out where it is, but sometimes gets confused and I need to set pose in rviz.
"Now I want to be able to map an area once. Then uses it over and over again."
I use hector_mapping to generate and save a map once, and then I use map_server to reload it and navigate it with AMCL and move_base.
Asked: 2017-02-07 08:26:40 -0600
Seen: 766 times
Last updated: Jul 27 '23
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
