| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
Dear all,
I am trying to connect my Ubuntu with ROS Hydro to ABB controller that is using IRB120 robotic arm, but I am unable to understand how to make it connect. I am looking at this 
. But I am unsure what the robot_ip parameters should be.
In short: after you have completed setting up your controller according to the official tutorial, the robot_ip argument should be set to the IP(v4) address of your IRC5 controller (either real or simulated).
This means you'll have to have configured networking correctly on your IRC5, and be able to ping the controller from your ROS PC.
If you only installed ROS Hydro because the PDF you linked instructs you to, I would recommend you start over with either Ubuntu Trusty (14.04) and ROS Indigo, or Ubuntu Xenial (16.04) and ROS Kinetic. The ABB packages are supported on both of these distributions and ROS releases. Then follow the official tutorial.
Asked: 2017-06-09 13:18:48 -0600
Seen: 1,288 times
Last updated: Jun 10 '17
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
First: please don't use ROS Hydro. It's long been EOLd, and you're missing out on a lot of improvements and support.
Second: can you please tell us where you found the text that you show in your question? I cannot find it in any of the official (ros-i) tutorials.
I got it from here: http://dspace.uah.es/dspace/handle/10017/20806
in chapter 15
The link, does not work anymore, do you have by any chance, the link updated?