| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
hello,
i am trying to program my robot so that he drives straight ahead until he is close to a wall or so, and then he should turn right or so... just drive ahead in a other way. So my question is, if i get my data from my sensors and make a map out of them, is there any way how i can use that information,or are there some packages at ros.org, to notice wehen i am to close to a wall? I am using a Hokuyu laser
hello,
you better start reading navigation tutorials
if you need something that simple you can write your own code. just subscribe your laser scan messages, put a threshold value (i.e 50 cm close to an object ) then send velocity commands or position commands to your robot's motor drivers. if you are not familiar with ros, you can start from here
hope this helps you out
Asked: 2012-07-12 22:27:38 -0600
Seen: 724 times
Last updated: Jul 12 '12
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
