| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I am trying to connect an LMS111 through my computer's ethernet port, and use it with the sicktoolbox_wrapper. Will the package work properly with an LMS1xx? Are there any changes to the tutorial steps I need to do, particularly concerning the permission configuration to the ethernet port (eth1 in my case), in order to make it work?
Hi,
For for LMS1xx Series I think the driver is here LMS1xx driver. I have used the driver package with SICK LMS100.
The command for running the driver after connecting it via Ethernet is
rosrun LMS1xx LMS100 _host:=192.168.0.1
where 192.168.0.1 is the IP of the Laser-scanner(I think IP I used is the default one, not sure though). Change it according to your IP settings.
Hello, I am in the same situation as the person who asked this question, and tried your solution (I had to modify if to the following: rosrun lms1xx LMS100.launch _host:=(my_ip_adress) in order for it to say it could find the files and stuff). However, now I am getting the error: cannot launch node of type [LMS1xx/LMS1xx_node]: LMS1xx ros path [0]=/opt/ros/hydro/share/ros ros path[1]=/opt/ros/hydro/share ros path[2]=/opt/ros/hydro/stacks no processes to monitor ANy idea what could be going wrong? Thanks, Randyh
Asked: 2013-07-02 08:26:06 -0600
Seen: 2,343 times
Last updated: Jul 03 '13
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
