ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange
Ask Your Question
0

ROS driver for specific GPS receiver? [closed]

asked 2014-08-12 15:54:59 -0600

mysteriousmonkey29 gravatar image

Hello, I'm currently trying to set up a GPS receiver and base station my boss purchased to work in ROS. It is a trimble Ag GPS 542 GNSS receiver. I tried looking online to see if there were any ROS drivers already written for this specific model, but didn't have any. I was wondering if anyone knew of any ros drivers that might be compatible with this device, either a specific one or a more general one that could be adapted specifically for use with this receiver.

Thanks!

edit retag flag offensive reopen merge delete

Closed for the following reason the question is answered, right answer was accepted by mysteriousmonkey29
close date 2014-08-14 16:49:24.741491

Comments

mysteriousmonkey29 gravatar image mysteriousmonkey29  ( 2014-08-12 15:55:36 -0600 )edit

1 Answer

Sort by ยป oldest newest most voted
1

answered 2014-08-12 16:57:00 -0600

updated 2014-08-12 17:00:19 -0600

Most GPS use NMEA 0183 that transmits a sentence over serial. Does it have serial port? If it does, try this nmea_navsat_driver. According to this manual it uses NMEA 0183.

edit flag offensive delete link more

Comments

Ok, I will try this out. Is it a problem that the project I'm going to try to integrate this into is in C++, while this package appears to be in python?

mysteriousmonkey29 gravatar image mysteriousmonkey29  ( 2014-08-13 13:03:40 -0600 )edit

Not if you are not modifying the code. If you just use the NavSatFix msg you should be fine.

tonybaltovski gravatar image tonybaltovski  ( 2014-08-13 15:47:17 -0600 )edit

Cool, not planning on modifying the code (provided it works as is). However, I am encountering some setup problems that I have turned into a new question here: http://answers.ros.org/question/19008... If you have time do you know what I'm doing wrong in the installation? I downloaded it with git clone but can't get catkin_make to recognize it as a new package, or to generate the actual executables I want to use.

mysteriousmonkey29 gravatar image mysteriousmonkey29  ( 2014-08-13 16:21:08 -0600 )edit

Question Tools

1 follower

Stats

Asked: 2014-08-12 15:54:59 -0600

Seen: 1,311 times

Last updated: Aug 12 '14