| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I want to re-position the kinect on turtlebot to the top of it, instead of the default position. Will i get a proper map now ? or should I change some robot-model-parameters to achieve that? If so what all parameters and where?
Hi, Default mapping by the gmapping uses the fake laser from the kinect. So the obtacles that are in the plane of the kinect's height will be detected. So if your environment has the obstacles of that height, then mapping should be fine even if you change the height. You can visualize the same in rviz. If you want to change the model of the robot in rviz then you may have to change the URDF of the robot. Please refer to the launch files and locate the model and try to edit it and see if the model is changed in rviz.
Hope it helps, Karthik
I used to put Kinect on top of Turtlebot and gmapping was as good as default config without really modifying mapping parameters. Adding to @karthik's thorough answer, one thing to note is to save enough space in front of Kinect (as default setting does) so as not to violate its minimum distance requirement toward objects.
Asked: 2012-04-01 22:26:45 -0600
Seen: 821 times
Last updated: Apr 02 '12
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
