ROS base - rviz
Can I install/start rviz, when I only have installed ROS base (Ubunto 10.04, electric)?
add a comment
The site is read-only. Please transition to use Robotics Stack Exchange
| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
You should install the ROS visualization stack if you want to use RVIZ:
sudo apt-get install ros-electric-visualization
You could basically also checkout RVIZ source and manually install all dependencies but i think you really should NOT do this...
This problem might be caused by Ogre or OpenGL. You can check:
http://www.ros.org/wiki/rviz/Troubleshooting
for Troubleshooting (especially section 3.4 might be of interest for you).
Thank you!
I install this stack, but when I like to start rviz with "rosrun rviz rviz" I get following information:
INFO [1334752437.645123296]: rviz revision number 1.6.7 INFO [1334752437.645302342]: ogre_tools revision number 1.6.2 INFO [1334752437.645396558]: compiled against OGRE version 1.7.3 (Cthugha) INFO [1334752437.714417048]: Loading general config from [/home/janina/.rviz/config] INFO [1334752437.714674451]: Loading display config from [/home/janina/.rviz/display_config] INFO [1334752437.757203727]: RTT Preferred Mode is PBuffer. INFO [1334752437.953380257]: Texture for pass 0: creating with size 1 x 1 Segmentation fault
Why do not start rviz?
Asked: 2012-04-18 02:16:39 -0600
Seen: 1,091 times
Last updated: Apr 18 '12
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.