| ROS Resources: Documentation | Support | Discussion Forum | Index | Service Status | ros @ Robotics Stack Exchange |
I have what looks like a very good localization of the robot to the map. But when overlaid with the current lidar scan data, the localization is just a little offset, but with high confidence. See attachment. What would cause that? How do I interpret that?
I think an incorrect static transform somewhere is causing this. Make sure that your laser_link to base_link tf is correct.
Also does this continue happening when you are moving? AMCL does not update when stationary (unless you explicitly call /request_nomotion_update) and therefore, if there is motion after the last update before stopping sometimes the laser scan will be offset from the static map.
But in all cases the offset is the same, then I think a static transform might be off.
Asked: 2020-10-15 08:51:42 -0600
Seen: 631 times
Last updated: Oct 15 '20
ROS Answers is licensed under Creative Commons Attribution 3.0 Content on this site is licensed under a Creative Commons Attribution Share Alike 3.0 license.
